Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Hello to everyone!!
I got to simulate a jet of dense fluid (such as synthetic oil) getting out from a plastic bottle neck... Should I use a fluid emitter or do you think it is better to use a particle emitter with blobby surface? Have you got any idea??
Thank you for your attention!!
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off