Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I'd imagine there's little to no differences. Have you checked Alias' site?
Linux, mac osx and irix are all unix based platforms and maya is available for all of them. I think Maya is most troublefree on a Red Hat linux but I believe it could be ran on other distributions as well if all required libraries and such are installed/configured. If there was more A/V apps available for linux i'd forget about windows completely...
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off