Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 06-04-2014 , 09:38 PM
Subscriber
Join Date: Feb 2013
Posts: 70

Extra CV's, or, partial faces...?

Following close on my previous post, I extruded four faces several times. All looked well until I noticed some extra CV's out of place when I looked at it in CV mode. It seems that one ring of CV's does not go all the way around. What causes this?

Attached Thumbnails
# 2 06-04-2014 , 10:42 PM
EduSciVis-er
Join Date: Dec 2005
Location: Toronto
Posts: 3,374
Not sure what caused this specifically, but it shouldn't be too hard to clean up. Experiment with using the "merge vertex tool" and the "interactive split polygon tool". It depends on whether you want to add or remove vertices. Just a note on terminology, these are actually vertices, as CVs are specifically components of NURBS and curves.

# 3 06-04-2014 , 11:43 PM
Subscriber
Join Date: Feb 2013
Posts: 70

Not sure what caused this specifically, but it shouldn't be too hard to clean up. Experiment with using the "merge vertex tool" and the "interactive split polygon tool". It depends on whether you want to add or remove vertices. Just a note on terminology, these are actually vertices, as CVs are specifically components of NURBS and curves.

OK. 'Always wanted to play with the Merge Vertex Tool. And...'vertices=polygons, CV's=NURBS'. Got it. Thanks.

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads