Beer glass scene creation
This course contains a little bit of everything with modeling, UVing, texturing and dynamics in Maya, as well as compositing multilayered EXR's in Photoshop.
# 1 12-10-2010 , 07:44 PM
Registered User
Join Date: Sep 2006
Posts: 2

Seams on Nurbs

There are subtle seems on Nurbs object. Does anyone knows how I can fix this?

Attached Thumbnails
# 2 13-10-2010 , 04:04 AM
hamidz90's Avatar
Registered User
Join Date: May 2010
Posts: 37
im not really sure but i think if you set your nurbs tessellation higher it should fix it, you can do this by selecting your nurbs object.....going in the rendering section then click on the menu called Render and then on set nurbs tesselation

# 3 13-10-2010 , 10:01 PM
Registered User
Join Date: Sep 2006
Posts: 2

Originally posted by hamidz90
im not really sure but i think if you set your nurbs tessellation higher it should fix it, you can do this by selecting your nurbs object.....going in the rendering section then click on the menu called Render and then on set nurbs tesselation

Thanks, I'll try that.

# 4 10-12-2010 , 09:01 AM
ctbram's Avatar
Moderator
Join Date: Jan 2004
Location: Michigan, USA
Posts: 2,998
Increasing tessellation will really not fix the seam issue. Seams between adjacent NURBs surfaces are caused by non-parallel surface tangents along the seam.

There are a number of ways to correct this. The easiest is to attach the two surfaces using the "blend" and 50% settings and then detach them. This will force the two surfaces to be tangent at the edges where they meet. Alternatively, you can select the two hulls that run parallel on both surfaces, closest to the seam, and make them all coplanar.

There are other solutions as well at some point I will make a small video tutorial to demonstrate in the mean time I will grab a couple screen shots to demonstrate the cause and one solution.


Here is the first image. It demonstrates what makes a seam invisible == crease less is TANGENCY.

user added image


This next image shows how breaking TANGENCY also creates a seam...

user added image

And here is one solution (attach with blend and then detach)...

user added image

Just a final note. Once you have tangency at two edges then as long as you keep the four hulls closest to the edge (two on each surface) planar you can do anything you want to all the OTHER cv's and hulls and there will never be a visible seam.


"If I have seen further it is by standing on the shoulders of giants." Sir Isaac Newton, 1675

Last edited by ctbram; 10-12-2010 at 10:42 AM.
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads