Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
can´t tell about the plugin, but embedded in/export format of both software I use is fbx file format (obj also sometimes for small geometries) which works pretty fine.
everything starts and ends in the right place at the right time.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off