Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Ok, well I know I have seen something like this in a thread before, but I have searched and searched and could not find it again. So, if you know where to look please lead me in the right direction.
My problem is with curves. I need a way to create pipes that follow a specific curve. So if I had one that look like a squigly line, and then converted it, it would come out like a pipe. So, if you all have any solutions please spread the wealth.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off