Introduction to Maya - Rendering in Arnold
This course will look at the fundamentals of rendering in Arnold. We'll go through the different light types available, cameras, shaders, Arnold's render settings and finally how to split an image into render passes (AOV's), before we then reassemble it i
# 1 04-02-2009 , 07:26 AM
Registered User
Join Date: Feb 2009
Location: India
Posts: 2

Regarding the Trim tool

Hi, I need to use the trim tool on the surface shown in the image but for some reason it is not working. The curve that's projected onto this surface is selected in the image. When I evoke the trim tool and try to select this surface no trimming takes place that is, it doesn't get converted into a white wire frame as it normally should. This isn't the first time it's happening like this. And I am using Maya 7.
Could any one tell me why it isn't working?
Any suggestion will be appreciated.
T.

Attached Thumbnails
# 2 05-02-2009 , 02:50 PM
Registered User
Join Date: Feb 2009
Location: India
Posts: 2
Hi, I managed to trim the surface by increasing the tolerance value for the trim tool. Don't see why though. The curve-on-surface goes from one edge to the other. I don't know what tolerance has got to do with it though.

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads