Introduction to Maya - Rendering in Arnold
This course will look at the fundamentals of rendering in Arnold. We'll go through the different light types available, cameras, shaders, Arnold's render settings and finally how to split an image into render passes (AOV's), before we then reassemble it i
# 1 01-02-2006 , 07:27 PM
pbman's Avatar
Subscriber
Join Date: Mar 2005
Location: London
Posts: 1,135

animation sweep

hey evry1!
i am haveing trouble with my animation sweep
i draw a cruve and rebuild it
make a nurbs circle and attackh it to it but strait away i get error saying i may get un expexted results
i then try to do the sweep - i get the new cirles but they are not lofted neither will they loft wen i select them all and chose loft

this is the error

// Warning: Cycle on 'addDoubleLinear1.output' may not evaluate as expected. (Use 'cycleCheck -e off' to disable this warning.) //


plz help as this is annoing me now as it worked on my power lead for my lamp like a week ago

thx in advanced


Now at SMU doing BSc 3D Computer Animation so its hard to get on here
My wire render tut https://forum.simplymaya.com/showthre...threadid=20973

Last edited by pbman; 01-02-2006 at 07:58 PM.
# 2 01-02-2006 , 09:14 PM
pbman's Avatar
Subscriber
Join Date: Mar 2005
Location: London
Posts: 1,135
WOO FIXED it i had forgotten that i had turned off display nurbs surfaces but still im not sure wat the error was about

next problem
wen i try to rebuild surface
it says the node failed to compute the result on valid selection
i remade and this time it dissappears so i done it again but now thet failed to compute error message comes up
ne 1 know what to do

thx


Now at SMU doing BSc 3D Computer Animation so its hard to get on here
My wire render tut https://forum.simplymaya.com/showthre...threadid=20973

Last edited by pbman; 01-02-2006 at 09:16 PM.
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads